![]() If no buttons are pressed for 30 seconds after turning on the power, the screen will turn off and enter Power Save / Ready Mode.Ģ. Press and hold the power button for 5 seconds and release the power button. Press and release the power button to wake up the screen.Ģ. If so, you are ok to proceed with camera use.ġ. Check the battery level icon to ensure the batteries just installed contain the proper charge level. Press and release the power button on the main control panel.Ģ. ![]() With the camera powered off, load the SD card with the label facing up and the grooves inserted first.ġ. If you are using a new card, it may go directly into this camera without any formatting.ġ. Hope this helps.If you are using an SD card from another camera, you must format the SD card in your computer prior to installing it in this camera. Viewing your manual, that camera doesn't have that switch setup. If I forget to slide the switch from setup to on, it will kill the batteries in a very short time. It has a three position slide switch: on, setup and off. In my case I have the 2009 model Bushnell Trophy camera. Your camera batteries should not have died in that short period of time unless something is hanging up when the camera tries to take a picture. If one has to return a camera under warranty, most manufactures request you obtain a return authorization number from them before sending the camera in. If your camera is either on or off warranty, contact the manufacture to see if the problem could be solved either by phone or email. ![]() Try checking your camera for proper operation before, either leaving the setup site or if the camera is at home, this would be better as you could do several checks during the day or evening. ![]() Once a battery is around the 1.0 to 1.2 volt reading, it does not have sufficient power to operate the camera properly. ![]() This instrument is far more acurate as it gives a digital reading. If possible use a multimeter to check the batteries before installing. You have probably gone over this lots: in the Initial Camera Set Up Section 6: re-check the battery charge icon level with new batteries. BarnesX.308: I just reviewed the manual for your camera again. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |